How To Attach A Deck To A House With Aluminum Siding. Hold a deck railing mount bracket on the spot you marked on the wall. Cut the siding and slip the flashing under the siding and about 1 1/2 on top of the boards and slip jay channel matching the siding to cover the edge.
Install the flashing under the siding. Slip the siding up under the siding board above. Position the hole 3 inches below the upper edge of the ledger and at a slightly upward angle.
Move The Nozzle Back And Forth Over The Stained Area And The Stain Will Start To Come Off.
Measure siding for a cutout. Depending on the brand, most vinyl siding hooks will hold up to 12 lbs. Slip the siding board behind siding.
Screw The Blocking On The Top And Bottom Edges To Secure Them.
Make sure the bottom of the siding will be at the desired height in relation to the decking. Any stray nails should be hammered flat or removed. This way all the water that runs along the siding will clear bolted ledger/joist.
Fill Any Dents Or Depressions Left In The Wall With Wedges (Small Pieces Of Scrap Material).
After properly installing the flashing, install the siding above the ledger as needed. Inserting nails or screws often voids the warranty and causes moisture damage from rainfall. In all cases you have to use flashing and / or caulking to prevent water penetration into the basement through the attachment.
Set The Blade Depth So You Won’t Cut Into The House Sheathing Below The Siding.
Cut the siding and slip the flashing under the siding and about 1 1/2 on top of the boards and slip jay channel matching the siding to cover the edge. You just drill 2 1/2 in. Position the hole 3 inches below the upper edge of the ledger and at a slightly upward angle.
Hold The Hook Facing Outward And Push It Under The Siding.
How do you attach ledger to siding? One of the most common questions is how to install a ledger board for a deck and today, i am. We cover how to move doors and windows and create a weatherproof exterior.